Recommended for use in Neoprene, EPDM, chlorobutyl and latexes. THIATE H offers fast initial set-up. It also provides continuous cured sponge, LCM extrusions and hot air cures. Suggested usage for this product is 0.5 to 1.0% on polymer. In Neoprene systems this accelerator notably provides import very low compression set valves.
Accelerator for EPDM, Neoprene and chlorobutyl compounds. Recommended for fast initial set-up in continuous cured sponge, LCM extrusions, and hot-air cures. Slightly slower set-up than THIATE H Accelerator, but better scorch resistance. Suggest 0.5 to 1.0% on the polymer.
DISCLAIMER: Before using, read, understand and comply with the information and precautions in the Safety Data Sheets, label and other product literature. The information presented herein, while not guaranteed, was prepared by technical personnel and, to the best of our knowledge and belief, is true and accurate as of the date hereof. No warranty, representation or guarantee, express or implied, is made regarding accuracy, performance, stability, reliability or use. This information is not intended to be all-inclusive, because the manner and conditions of use, handling, storage and other factors may involve other or additional safety or performance considerations. The user is responsible for determining the suitability of any material for a specific purpose and for adopting such safety precautions as may be required. Vanderbilt Chemicals, LLC does not warrant the results to be obtained in using any material, and disclaims all liability with respect to the use, handling or further processing of any such material. No suggestion for use is intended as, and nothing herein shall be construed as, a recommendation to infringe any existing patent, trademark or copyright or to violate any federal, state or local law or regulation.