Tecnoflon® PL 458
Fluoroelastomer (FKM)
Tecnoflon® PL 458 is a new generation low post cure peroxide curable fluoroelastomer. Tecnoflon® PL 458 exhibits both excellent low temperature flexibility (TR10 = –24°C) and an outstanding resistance to a variety of chemicals. As all other Tecnoflon® peroxide curable grades, it exhibits excellent processability; moreover it needs very short post-curing cycles.
Some of the basic properties of Tecnoflon® PL 458 are:
- Excellent low temperature flexibility
- Low volume swell in methanol-based fuels
- Low post cure
- Superior mold flow
- Lack of mold fouling
- Excellent mold release
Tecnoflon® PL 458 can be used for injection, compression and transfer molding of O-rings, gaskets and seals. Tecnoflon® PL 458 can be combined with the cure system and other typical fluoroelastomer compounding ingredients. Mixing can be accomplished with two roll mills or internal mixers. Tecnoflon® PL 458 can be extruded into hoses or profiles and can be calendered to make sheet stocks or belting. Finished goods may be produced by a variety of rubber processing methods.
Some of the basic properties of Tecnoflon® PL 458 are:
- Excellent low temperature flexibility
- Low volume swell in methanol-based fuels
- Low post cure
- Superior mold flow
- Lack of mold fouling
- Excellent mold release
Tecnoflon® PL 458 can be used for injection, compression and transfer molding of O-rings, gaskets and seals. Tecnoflon® PL 458 can be combined with the cure system and other typical fluoroelastomer compounding ingredients. Mixing can be accomplished with two roll mills or internal mixers. Tecnoflon® PL 458 can be extruded into hoses or profiles and can be calendered to make sheet stocks or belting. Finished goods may be produced by a variety of rubber processing methods.
Thank you for Requesting a Quote.
A Vanderbilt associate will contact you shortly.
Something went wrong with your submission.
Please refresh the page and try again.